This page gives a good introduction in how to get started with Glances. Glances offers 3 modes:

  • Standalone
  • Client/Server
  • Web server

Standalone Mode

If you want to monitor your local machine, open a console/terminal and simply run:

$ glances

Glances should start (press ‘q’ or ‘ESC’ to exit):


Client/Server Mode

If you want to remotely monitor a machine, called server, from another one, called client, just run on the server:

server$ glances -s

and on the client:

client$ glances -c @server

where @server is the IP address or hostname of the server.

In server mode, you can set the bind address with -B ADDRESS and the listening TCP port with -p PORT.

In client mode, you can set the TCP port of the server with -p PORT.

Default binding address is (Glances will listen on all the available network interfaces) and TCP port is 61209.

In client/server mode, limits are set by the server side.

You can set a password to access to the server --password. By default, the username is glances but you can change it with --username. It is also possible to set the password in the Glances configuration file:

# Define the passwords list
# Syntax: host=password
# Where: host is the hostname
#        password is the clear password
# Additionally (and optionally) a default password could be defined

If you ask it, the SHA password will be stored in username.pwd file. Next time your run the server/client, password will not be asked.

Central client


Glances can centralize available Glances servers using the --browser option. The server list can be statically defined via the configuration file (section [serverlist]).


# Define the static servers list

Glances can also detect and display all Glances servers available on your network via the zeroconf protocol (not available on Windows):

To start the central client, use the following option:

client$ glances --browser


Use --disable-autodiscover to disable the auto discovery mode.


As an experimental feature, if Glances server is not detected by the client, the latter will try to grab stats using the SNMP protocol:

client$ glances -c @snmpserver


Stats grabbed by SNMP request are limited and OS dependent. A SNMP server should be installed and configured...


Glances is IPv6 compatible. Just use the -B :: option to bind to all IPv6 addresses.

Web Server Mode


If you want to remotely monitor a machine, called server, from any device with a web browser, just run the server with the -w option:

server$ glances -w

then on the client enter the following URL in your favorite web browser:


where @server is the IP address or hostname of the server.

To change the refresh rate of the page, just add the period in seconds at the end of the URL. For example, to refresh the page every 10 seconds:


The Glances web interface follows responsive web design principles.

Here’s a screenshot from Chrome on Android: